Hot Tub Removal in Orlando, FL

Hot tub removal in Orlando comes up in four scenarios, in roughly that order of frequency: the spa is broken (cracked shell, dead pump, failed heater) and the cost to repair is more than the unit is worth, the homeowner is putting in a new in-ground pool and the existing spa is in the way, a foreclosure or estate cleanout includes a hot tub nobody knew was there, or the owners simply do not use it anymore and the screen patio could be a sitting area instead. In every case the unit is too big to move intact, too heavy to lift, and too plumbed and wired to just drag out. It needs to be taken apart, on-site, in pieces — and that is what we do.

The standard process takes 2 to 4 hours with a 2 or 3 person crew. We start by fully draining the tub — through the built-in drain plug if it still works, or with a submersible pump if it does not — and routing the water to your yard or to a curb storm drain depending on local code. We then disconnect the electrical: we pull the power cord at the spa pack, but we do not touch the breaker panel (that is a licensed electrician's job; if your panel needs the breaker pulled and the rough-in sealed, we will coordinate with one for you). Plumbing connections to a hard-line system get capped at the wall.

With the unit drained and disconnected, we cut the shell into haulable pieces using a reciprocating saw — typically the acrylic top into two or three sections, the foam insulation pulled out by hand, and the wood or composite cabinet into manageable panels. We work from the inside out so the saw never approaches your deck, pavers or screen enclosure. Pieces get carried out one at a time, loaded onto the truck, and the spa pack (the pump/heater/control unit) goes separately. The whole disassembly happens on a tarp so foam particles and acrylic dust do not blow into your pool or your neighbor's yard.

Protecting your surrounding hardscape is the part most people do not think to ask about, but it is what separates a clean job from a regrettable one. We lay moving blankets and plywood pieces over the deck planks, the pavers around the tub, and any pool coping the crew has to step on. Screen enclosures get special attention — the saw never gets close to the screen frame, and we hand-carry every piece through the screen door (or, if the tub was built in before the screen, we will tell you up front whether a screen panel will need to come out and be re-installed). You should see no scratches, no dents, no torn screens when we leave.

Pricing in Orlando for a hot tub removal typically runs $349 to $899, with most jobs landing in the $499 to $699 range. The variables are size (a 4-person tub is at the low end, an 8-person swim-spa is near the top), location (on a deck is faster than on a concrete pad with steps around it, which is faster than inside a screen patio with a single narrow door), and access (driveway-to-back-yard distance matters because every piece has to be carried). We quote flat from a photo or after a free site walk-through — never an open-ended hourly rate.

A few notes before you book. The concrete pad under the tub stays — we do not break it up as part of the hot tub price. If you want the pad removed too, that is our light demolition service (separate scope, separate quote, see /services/light-demolition). We do not service or repair the spa equipment; if you want the pump or heater salvaged for parts, tell us up front and we will set it aside instead of crushing it. We are licensed, fully insured ($1M general liability), and our crews carry workers' compensation — credentials we will send to your HOA if they ask.